营口驾考科目一英文版
1、When driving in thick or extremely thick fog, the driver should ____ due to low visibility.
A. Turn on the head light and keep driving
B. Turn on the contour light, fog light and drive along the right side
C. Turn on the hazard lights and keep driving
D. Turn on the hazard lights, fog light, and stop at a safe place
Answer：D
2、Whats the meaning of this sign?
A. stop to yield
B. one-way road
C. going first when crossing each other
D. the opposite vehicle goes first when crossing each other
Answer：C
3、What is this manipulation device?
A. the air throttle lever
B. the gear lever
C. the clutch lever
D. the handbrake
Answer：D
4、The double yellow solid lines in the middle of the road are used to separate the traffic flow in opposite directions, crossing the lines to overtake or make a turn is allowed if it is safe.
A. Right
B. Wrong
Answer：B
5、Driving a motorized vehicle on the expressway is not allowed to exceed the marked maximum speed.
A. Right
B. Wrong
Answer：A
6、Whats the meaning of the white solid lines at the edge of the carriageway on both sides of the road?
A. Vehicles may cross temporarily
B. Vehicles are not allowed to cross.
C. Motorized vehicles may cross temporarily.
D. Non-motorized vehicles may cross temporarily
Answer：B
7、Which part does it control when rotating this part of the switch?
A. the low beam lights
B. the head and tail fog lights
C. high beam lights
D. turn signals
Answer：B
8、Which kind of sign is it?
A. tourist zone sign
B. work area sign
C. notification signs
D. expressway sign
Answer：A
9、When an accident has caused congestion on an expressway, the vehicles may run in the emergency strip on the right or in the shoulder of the road.
A. Right
B. Wrong
Answer：B
10、When following a vehicle on the road, the distance from the vehicle in front is not important. As long as the driver goes forward at the same speed as the vehicle in front does, he can avoid rear-end collision.
A. Right
B. Wrong
Answer：B
11、Whats the meaning of this sign?
A. stop to yield
B. no stopping temporarily
C. no entry
D. no long stopping
Answer：A
12、Whats the meaning of the double white solid lines in far front of the intersection?
A. stopping and yield line
B. slowdown and yield line
C. left-turn waiting line
D. waiting to run line
Answer：A
13、When a vehicle changes lane before an intersection, the driver should do so ______.
A. In the area marked by solid lines before the intersection
B. In the area marked by solid lines in the intersection
C. In the area marked by broken lines as indicated by the guide arrow
D. Before the stop line at the intersection
Answer：C
14、What mark is the inclined yellow and black lines?
A. entity mark
B. protrusions mark
C. three-dimensional mark
D. deceleration mark
Answer：C
15、Whats the meaning of the yellow slash filled area in the middle of the road?
A. one-way lanes dividing line
B. opposite direction lanes dividing line that can not be crossed
C. bilateral same direction lanes dividing line that can be crossed
D. opposite direction lanes dividing line that can be crossed
Answer：B
16、Whats the meaning of this sign?
A. embankment road
B. dangerous hillside road
C. rock-falling road
D. cliffside road
Answer：B
17、As the braking distance increases on a wet road in a rainy day, the driver should use the emergency brake as much as possible to reduce speed.
A. Right
B. Wrong
Answer：B
18、When the light switch is rotated to the position, the whole car lights turn on.
A. Right
B. Wrong
Answer：B
19、You may speed up to go through the intersection in this case.Answer￡o
A. Right
B. Wrong
Answer：B
20、After entering the acceleration lane of an expressway, the driver should increase the speed to more than _________ per hour.
A. 50
B. 60
C. 30
D. 40
Answer：B